l»<è) ]< u »9èé豺¹ÍàþÀu»ë籺ÚÍàþÀu»¨ë×2À¢Ù¢ú¢û¢ÿÆüÆÇý¹Š&û€äuIŠ&üþÌu;Q¹º»¹èQ¹º »ÚèöX:åt»ÿrˆìÆ2éÆ1Y€üt4º» ˆ&ü´€þ̈&û‡ÚŠ‡Ú:tè6èÐÈrABCëèÕ»ûè[QèË»ÁèQ[èõ°HèÎè¹»Þè?‹ýèà°Hè¹è¤ ÿ Àt»º<1t»Ûè»è²±Íൺ\»¹è,»%èÿ»ºèùèjµºl»Úè»/èå»ÛèßèPéM‡ÚŠ‡ÚˆBCþÍuòºùÿÚŠ< u ÆCCÆMCÆDÃQRS±ÍàZR±ÍàZ[¹€Ù‡ÚY<uþÅþÉußÃ<uÃð è ° éèè° SRQˆÂ±ÍàYZ[ÃQRS± ÍàPÐÈs±ÍàX[ZYÈøèˆØPÐØÐØÐØÐØèX$'@'ëÀSQ‹ýC‰ý[èÓÿè©ÿ[ŠèÑÿè£ÿ‡ÚŠ‡ÚèÅÿè—ÿèŽÿ þÈuèzÿ°¢Ê Àtè}ÿCëôà BINCOM/ICUAP Universidad Autonoma de Puebla September 16, 1983 Cannot open first file.Cannot open second file.Number of bytes compared: Number of mismatches found: Comparison interrupted... was shorter. File 1: File 2: BINCOM.CMD is a program which can be used to compare two files, which will probably be binary, to find the differences between them. The files are compared byte for byte. No attempt is made to vary the match points to establish a different synchronization if a prolonged mismatch is found, as would be done for ASCII files. The command line is: BINCOM [X:]FILE1.CMD,[Y:]FILE2.CMD Discrepancies will be noted in the form XXXX YY ZZ where XXXX is the discrepant byte, YY in FILE1 but ZZ in FILE2. Use any key to halt the comparison. Final totals - of bytes compared and mismatches found - will always be shown.